Suchergebnisse

Testing at 1.825v (never tested at 1.800v) for PI32M stabilty. Since I was clicking around in XP while running it seemed rock solid...

I can try PI 32M later. I probably won't be optimizing much for a test run.

I did some boot tests (no benches) on my Epox 8RDA6+ Pro with an untested 2800+XP-m (IQYHA 0431 EPBW). It seems to be great CPU: 2695MHz@1.775v (BIOS) 2750MHz@1.850v (BIOS) 2784MHz@1.900v (BIOS) 2812MHz@1.950v (BIOS) Just too bad it is worse then my Nr. 1 2800+ XP-m. That would have...

I made a run back then as well. Could probably be faster too. No Eram etc. https://hwbot.org/benchmarks/superpi_-_32m/submissions/4703161

Is it not CH5 then (2.9v+)? 2.9v is often to low. Earlier this week I had to go to 3.4v+ to do 240-250MHz (that were not my best dimms but still).

What DDR voltage are you using?

I almost never bench on air or water with 1.85v or higher. Some chips degrade (like my 2600+ Tb did).

The Athlon XP 2900+ I tested is not so bad. It is an AQYHA batch and sadly locked at 10x. I was running on motherboard (8RDA6+) limits with these settings now. Boot was at 1.750v (mem at 3.60v, not my best set)

I can try

So the first 3 I tested were dead... Sadly including the AXDA2600DKV3C.

But if it is not soldered, does it not come off easily then? I remember I still have a bad bin pentium d dual core. I just delided it like I usually did some years ago. It still works but I use it as a socket protector.

It is not soldered to the ihs?

@Da_Maddy and @schemmi You are the only ones interested I think. Still interested? I will do a randomizer soon then.

I will do a randomizer action if more will come.

So I have a good give a way. Not crushing or destroying of hardware this time... 1x Asus Maximus Ranger VII 1x Xeon E3-1267V3 2x Corsair 2x4GB (1600MHz C9 v2.12). This is a combination of 1 give away (so all goes to one person) I noticed this board had one bent pin in it's socket. The CPU will...

https://ebay.us/m/nP1yhM

That is a nice cpu. That is actually much better then my best one (3200+) is. But then again, I did focus on unlocked ones for cold. I should test my untested Athlon XP’s. I still have 11 pieces to test. AMD Duron 1200 DHD1200AMT1B AHLDA 0222MPMW AMD Sempron 2500 SDA2500DUT3D BIXJB...

https://ebay.us/m/yh5wFO

I can understand it is hard to run then. I guess that is why I use LN2.

-190C, full pot. Just a CB post at -125C.