Aktueller Inhalt von Nightguest

In the end, my 3733CL17 was on the very edge of stability - I had 1 BSOD this week, so had to do some fixing. A TM5 test left overnight gave me 2 errors, which pointed out what was wrong: 1. ProcODT/SOC was too low 2. tWTRS/L and tRTP had a slight hiccup. Fixes: ProcODT is now up the 40...

A big milestone for me - 3733 CL17 has been unlocked and is stable! 8-) Passed 4 cycles of Memtest86 (I booted in via USB as I wanted to catch the 'worst' instability before going into windows). I'm pretty sure that this step saved me a bit as I needed to quit/change timings 3 times before I...

I'm back with more c-die fun, this time I spent most of my efforts on optimising the power settings as I felt (and verified) that that was what was holding me back. From the power setting changes I managed to bring tRAS down from 42 to 39, not much but every last bit helps! The biggest...

Another weekend and another Saturday spent on my RAM with some nice results! AIDA tends to vary between 67.5-67.3 ns for latency, however, I have got 67.3 more than once (so it wasn't a one-off-best-case situation, hence I'm using it). The above settings are still with the same...

Hey folks, I've got a question that has been nagging me for a while. It's been written in many places (including here) that c-die should not go over 1.35v. I pretty much went with that and have even advised others with c-die not to go over that. However, I realized that I've not really read any...

From 05/09 Another Saturday and a bit more improvement to my RAM OC. Still with 3733 (no luck with FCLK 1900, pretty much going to give up on that). Achievement of the day was getting the latency to 67.9ns, previously I was stuck at 68.xns (AIDA and Timings here) Compared to the original...

@Myrkin As Kammi wrote, there is no entry for c-die in the dram calculator, just throw that away. If you can share the settings that you've used to get your 3200CL18 working, it may help others to identify what you can improve. Also, do go back a few posts and pages, there are other ENG people...

You say that now, however, I tried to put GDM off and bring TRFC down to 584. Booted into windows and ran 5 cycles of MemTest64 1usmus (I know short) and had no problems. But then AIDA failed in 10 minutes and windows refused to boot up after that. I reverted the changes and windows BSOD'd on...

I know that this is a primarily German thread, so sorry for the English. That said, I wanted to thank pretty much everyone here for making this extremely valuable thread! I've had the Corsair Vengence LPX 3200CL16 for a while (c-die to no surprise) and it was a struggle to get anywhere with it...