Hab einen Raid Controller für ein selber gebautes NAS an dem hängen 8 Festplatten und nun müsste ich da LED's dranmachen damit ich schnell sehe wenn was defekt ist etc...
Was brauche ich dazu alles und wo bekommt man das LED zeug?
Ich kann folgende LEDs dranmachen:
Write-pending Indicator (dirty cache) LED connector.
2-pin connector
Connects to an LED that indicates when the data in the cache has yet
to be written to the storage devices. Used when the write-back feature is enabled.
SAS Activity LED header
2-pin connector
Connects to an LED that indicates drive activity.
Global Drive Fault LED header
2-pin connector
Connects to an LED that indicates
whether a drive is in a fault condition.
Individual Drive Fault LED header for Eight Phys (0-7)
16-pin connector
Indicates drive faults. There is one LED per port. When lit, each LED
indicates the corresponding drive has failed or is in the Unconfig-
ured-Bad state. Refer to the MegaRAID SAS Software User’s
Guide for more information.
The LEDs function in a directattach configuration (there are no
SAS expanders). Direct attach is defined as a maximum of one
drive connected directly to each port.This header is used for RAID
controllers with internal SAS ports.
Was brauche ich dazu alles und wo bekommt man das LED zeug?
Ich kann folgende LEDs dranmachen:
Write-pending Indicator (dirty cache) LED connector.
2-pin connector
Connects to an LED that indicates when the data in the cache has yet
to be written to the storage devices. Used when the write-back feature is enabled.
SAS Activity LED header
2-pin connector
Connects to an LED that indicates drive activity.
Global Drive Fault LED header
2-pin connector
Connects to an LED that indicates
whether a drive is in a fault condition.
Individual Drive Fault LED header for Eight Phys (0-7)
16-pin connector
Indicates drive faults. There is one LED per port. When lit, each LED
indicates the corresponding drive has failed or is in the Unconfig-
ured-Bad state. Refer to the MegaRAID SAS Software User’s
Guide for more information.
The LEDs function in a directattach configuration (there are no
SAS expanders). Direct attach is defined as a maximum of one
drive connected directly to each port.This header is used for RAID
controllers with internal SAS ports.